The REDARC BCDC1225D under bonnet Battery Charger is a 12V 25A DC to DC battery charger, capable of high performance in engine bay installations, potted to survive and thrive against heat, water and dust.

Featuring a Maximum Power Point Tracking (MPPT) solar regulator, the BCDC1225D Classic will charge from both solar and the alternator simultaneously. And, with built-in ‘Green Power Priority’ it will select solar charging first, meaning less load on the alternator.

Suitable for 12 or 24-volt vehicle systems, the unit will also work with either standard or variable/smart alternators.

The BCDC1225D features the same patented charging profiles as it’s predecessor along with a new lithium charging profile making the unit suitable for charging AGM, Gel, Standard Lead Acid, Calcium and LiFePO4 batteries, perfect for pairing with a REDARC Lithium battery.

For most applications, the BCDC1225D is suitable for battery bank sizes of 75-200AH. For higher capacity needs of over 200AH, REDARC recommends the BCDC1240D.

Proven and Tested

The award-winning technology in the BCDC has been independently verified and tested to ensure battery life is maximised, charging your battery to a proven 100%.

Built in Australia and tested for our unique conditions, the DC to DC battery charger will work in the extreme heat of the Simpson Desert, up to 80°C and can handle deep water crossings at Cape York – water, dust and vibration are no match for this charger.

If you’re heading out into the bush and want to get there and back again safely – you can trust REDARC.

Features

• Separate DC and solar charging inputs
• Maximises the performance and life of your auxiliary battery
• Simultaneous DC and solar charging with Green Power Priority
• Suits 12V/24V standard and variable voltage/smart alternators
• Suitable for AGM, GEL, standard lead acid, calcium and Lithium (LiFePO4) batteries
• Suitable for use on vehicles with conventional alternator charging systems

Tow without limits with the Tow-Pro Elite. Smooth and confident trailer braking on all terrain and in all conditions. The Tow-Pro Elite sets the benchmark in trailer brake control and remains Australia’s favourite and most trusted brake controller.

SAFE TOWING IN ALL CONDITIONS

Tow-Pro Elite is the only trailer brake controller with two modes – automatic/proportional for highway driving and gravel roads and user controlled mode for off-road control. Tow-Pro Elite gives you the best of both worlds with smooth braking for the road and accurate control for the sand, mud and dirt. With a Tow-Pro Elite on-board you can tow where others can’t.

SAY NO TO TRAILER SWAY

Avoid the dangers of caravan sway with the Tow-Pro’s manual override function. With the push of a button, the driver or passenger can apply the caravan brakes independently of the vehicle and bring a swaying trailer in line.

HIDDEN INSTALLATION

The Tow-Pro Elite hides behind your dash, keeping it away from your knees and airbag. Once installed only the Tow-Pro’s dial is visible inside the vehicle.

COMPATIBLE WITH ALL MODERN VEHICLES

The next-generation Tow-Pro Elite ensures compatibility with all new vehicle technology and also still features Active Calibration, works with Electric and Electric/Hydraulic trailer brakes, supports 12 or 24 volt vehicle systems and ensures an ADR approved installation. It has also been approved by AL-KO for use with their ESC and DSC systems. It also ensures the remote head will fit into thicker and curved dashes found in European vehicles and trucks.

The REDARC Smart Start® SBI2 is a microprocessor-controlled battery isolator used in dual battery systems as a solenoid priority system. It will protect the start battery from excessive discharge, whilst allowing the auxiliary battery to supply non-essential loads. The SBI2 provides 12 volt DC incorporating 100A of continuous ratings.

POWER SAVING TECHNOLOGY

The battery isolator is primarily used in 4WD and commercial vehicles and incorporates electronic components that will prevent the solenoid from generating high voltage transients. It is better than a diode battery isolator due to the voltage drop associated with diode type isolation. It features a low standby current draw and sophisticated fault detection and LED indication of operation to warn the user of faults including over-voltage, voltage drop and excessive current draw conditions.

The Smart Start SBI12 battery isolator is a safe way to charge a dual battery system and should often be installed with a high quality fuse kit.

FEATURES

• Overmould design
• Compact in size and easy to install
• Silver contacts for longer life and suitable for marine applications
• Power saving technology
• Fault indication
• Fully surge protected

Please note all Xrox bars are made to order. Current lead time estimate is 7-8 weeks from order payment confirmation to dispatch.

Born from the demands of serious off-road competition, Xrox® bars deliver the results you want – serious good looks, extreme off-roading capabilities, airbag  and ADR compliant and the durability that real steel and Australian design delivers.

Xrox® gives you the protection you need with the clearance you crave. Lighter than traditional bullbars, our smart “winged” design allows for fast easy replacement while maintaining strength.

Steel cross over tube bullbars are the ultimate in offroad and hard terrain driving. The steep incline of the side wings allow for greater approach angles by giving the wheels more upward clearance and free them to turn for difficult ascents.

XROX Bullbars are also bead blasted and coated in a heavy-duty powder coat for a tough and professional finish. The unique three-piece design also allows for simple shipping and easier repair or parts replacement.

XROX bars are also coated in a durable zinc undercoat to help prevent the possible development of corrosion and surface rust.

Each bar contains 9 multi-function tags for the fitment of aerials, spotlights and sand flags, giving the option for a truly modular fit out. Built in hi-lift jack points together with mounting positions for winches, tow hooks, recovery eyes, lights, aerials and sand flags gives you the versatility you need.

• 2 x Hi Lift Jacking Points.
• 9 x Aerial / Sandflag / Spotlight Tabs.
• Constructed from 2″ Steel Tube.
• Finished in Black Powdercoat.
• Detachable Side Wings (can be easily replaced if damaged).
• Supports Low Mount Winch (mounts directly to bar)
• Airbag Compatible.
• Improves Ground Clearance & Approach Angles.
• Designed & Manufactured in Australia.

DISCLAIMER:

Any XROX Bar with NO LOOPS and/or 50mm Body Lift are custom made and are non-refundable.